額定測量電流:±300A~±2000A;測量范圍:±600A~±2500A;額定輸出電壓:±5V
零點失調電壓:±20mV;電源電壓:±15VDC(±5%)
通過ISO 9001:2015; 完全符合RoHS和REACH要求

安裝方便
體積小,節省空間
無插入損耗
抗干擾能力強

交流變速驅動器
直流電機驅動靜態轉換器
通訊電源
不間斷電源
開關電源
電焊機

通過ISO 9001:2015
參考標準∶JB/T 7490-2007;
儲存環境∶溫度-40℃~ +125℃, 相對濕度∶不大于 95%(25℃)
電氣性能 ELECTRICAL PROPERTIES( 除非另有說明,否則環境參數均為@ TA = 25℃,RL = 10 k?) | |||||
型號 | KZ4-300A | KZ4-500A | KZ4-1000A | KZ4-1500A | KZ4-2000A |
額定測量電流Rated input IP | ±300A | ±500A | ±1000A | ±1500A | ±2000A |
測量范圍Measure range IPM | ±600A | ±1000A | ±2000A | ±2500A | ±2500A |
額定輸出電壓Rated output voltage VOUT | ±5V | ||||
零點失調電壓Offset voltage VO | ±20mV | ||||
電源電壓Supply voltage VC | ±15V DC(± 5%) | ||||
負載電阻Load resistance RM | ≥10KΩ | ||||
線性度Linearity εL | ≤0.5%FS | ||||
總體精度Overall accuraty X | ±1%FS | ||||
零點失調電壓溫漂Offset voltage drift VOUT | ±0.5mV/℃ | ||||
幅度電壓溫度漂移VOUT Amplitude voltage temperature drift | ≤0.05%/℃ | ||||
靜態電流消耗Current consumption IC | ≤40mA | ||||
頻帶寬度Frequency bandwidth-3db BW | DC-20KHz | ||||
響應時間Response time TR | ≤3us | ||||
di/dt跟隨精度di/dt accurately followed | >50A/us | ||||
絕緣耐壓Galvanic isolation VD | 50Hz,1min,5KV | ||||
工作環境溫度Ambient operating temperature TA | -25~+85℃ | ||||
儲存環境溫度Ambient storage temperature TS | -40~+95℃ | ||||
質量Mass m | ≈250g | ||||
定制Customized: 如上表沒有適合您使用的產品,我司可根據您的技術和結構要求為您量身定制產品。請聯系我們。

機械特性Mechanical characteristics | |
一般公差General tolerance | ± 0.5 mm |
其它公差執行 Other tolerance execution | GB/T 1804-2000-M |
連接器Connection of secondary | 2510-4P |
固定孔尺寸 Fixing hole size | Φ4.5mm |
緊固螺絲Fastening steel screw | M4 |
建議緊固扭矩 Recommended fastening torque | 1.0Nm (± 10 %) |
建議焊接溫度 Recommended wave soldering temperature | 265℃±5℃ |
注意Remarks:
錯誤的接線可能導致傳感器損壞。
The false wiring may result in the damage of the sensor.
Ip方向與產品箭頭方向一致時,輸出電壓為正極。
VOUT is positive when IP flows in the direction of the arrow.
當初級導體完全充滿初級孔徑時動態表現(di/dt和響應時間)為最佳效果。
Dynamic performances (di/dt and response time) are best with a single bar completely filling the primary hole.
初級導體的溫度不應超過100℃。
Temperature of the primary conductor should not exceed 100°C.
